Guía de selección de tubería para refrigeración líquida en centros de datos de IA

Data-center liquid cooling splits into a facility water side and an IT or secondary side. The CDU (cooling distribution unit) bridges them. Piping is typically 316L stainless for corrosion resistance and cleanability; for direct-to-chip cold plates a dielectric fluid loop may use different materials. Routes run from chilled water plant to CDU to rack manifolds to quick-connects at servers. TOKO TECH supplies 316L hygienic tube and fittings (orbital-weld ready) sized for CDU flow and pressure with clean, capped ends.

Two loop types: (1) water or glycol loop (facility plus CDU secondary) — 316L is standard, corrosion-controlled with inhibitors and filtration; (2) dielectric fluid loop (direct-to-chip, single-phase or two-phase) — uses specially formulated fluids; wetted metals must be compatible to avoid degradation and particulate. The CDU isolates the loops so a dielectric leak never reaches facility water. TOKO TECH specifies 316L and compatible alloys per loop chemistry and supplies verified-clean tube to avoid contaminating dielectric fluids.

Liquid cooling loops are sensitive to particulate that can clog microchannels in cold plates and quick-connects. 316L hygienic tube (ASTM A270 or A249) with low Ra ID (often 0.8 μm electropolished) and passivation (ASTM A967) minimizes corrosion product and biofilm. Pipe is delivered capped, bagged, and often purged to keep the bore clean until orbital welding. TOKO TECH supplies 316L tube with documented ID cleanliness and passivation certs for CDU and manifold fabrication.

Closed-loop water is mostly benign but can corrode via dissolved oxygen after make-up, low pH, or stagnant zones. 316L resists general corrosion; maintain pH 8–9.5 with inhibitors, filter to remove particulate, and avoid mixing dissimilar metals (galvanic). Excess chlorides from make-up water can pit 316L, so monitor Cl-. TOKO TECH advises material and water-treatment compatibility and supplies 316L with low extractable iron so the loop starts clean and stays stable.

CDU secondary loops run low pressure (often 2–5 bar) with moderate flow to racks. Use sanitary clamp or engineered quick-connect couplings for tool-free server connection and disconnection. Size tube (often 1/2 to 1 in OD) for design flow and velocity (below 2 m/s to limit erosion) and minimize bends to cut pressure drop at the cold plate. TOKO TECH supplies tube cut to length with square, deburred ends ready for orbital weld or clamp assembly into manifolds.

Specify 316L to ASTM A270 (sanitary) or A249 (welded tube), with passivation per ASTM A967 and roughness per ASME BPE where biopharma-grade cleanliness is desired for DC loops. Require EN 10204 3.1 MTC, PMI, and a cleanliness or documentation pack. TOKO TECH provides 316L hygienic tube and fittings with full certs, ID Ra verification, and passivation reports so the cooling loop passes acceptance and commissioning without rework.